Panasonic WV-SW352 Guia de Instalação descarregar pdf (Página 29)

Waterproof treatment for the cable joint sections

Adequate waterproof treatment is required for the cables when installing the camera with cables

exposed or installing it under the eaves. The camera body is waterproof, but the cable ends are not

waterproof.

Be sure to use the supplied butyl rubber tape at the points where the cables are connected to

apply waterproof treatment in the following procedure. Failure to observe this or use of a tape other

than the provided butyl rubber tape (such as a vinyl tape) may cause water leakage resulting in mal-

function.

LAN cable

Alarm input/output cable, power cable, microphone/line input cable, audio output cable

Important:

 • Waterprooftreatment is also to be appliedtothe2Ppowercable(accessory), the 4P alarm

cable (accessory) and other connection cables if they are subject to rain.

Note:

 • Howtowindthesuppliedwaterproofbutyltape

Stretch the tape by approx. twice (see the illustration)

and wind it around the cable. Insufficient tape stretch

causes insufficient waterproofing.

 • Toinstallthisproductoutdoors,besuretowaterproof

the cables. Waterproof grade (IEC IP66 or equivalent) is

applied to this product only when it is installed correctly

as described in these operating instructions and appropriate waterproof treatment is applied.

The mount brackets are not waterproofed.

Wind the tape in a

half-overlapping manner.

Wind the tape in a

half-overlapping manner.

Wind the tape in a

half-overlapping manner.

Wind the tape in a

half-overlapping manner.

Stretch the tape to

about twice.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Sem comentários

Panasonic WV-SW352 Guia de Instalação Página 29