Panasonic WV-SW352 Guia de Instalação descarregar pdf (Página 14)

Precautions for installation

This product is designed to be installed

under eaves.

Install the product under eaves to avoid direct

sunlight.

Installing place

Contact your dealer for assistance if you are

unsure of an appropriate place in your particu-

lar environment.

 • Make sure that the installation area is

strong enough to hold this product, such

as a concrete ceiling.

 • Installthecamerainthefoundationareaof

the architecture or where sufficient strength

is assured.

 • If a ceiling boardsuch as plasterboardis

too weak to support the total weight, the

area shall be sufficiently reinforced.

Do not place this product in the following

places:

 • Locationswhereachemicalagentisused

such as a swimming pool

 • Locationssubjecttohumidity,dust,steam

and oil smoke

 • Locations where a radiation, an X-ray, a

strong radio wave or a strong magnetic

field is generated

 • Locations where corrosive gas is pro-

duced, locations where it may be damaged

by briny air such as seashores

 • Locations where the temperature is not

within the specified range (page 44).

 • Locations subjectto vibrations(Thisprod-

uct is not designed for on-vehicle use.)

 • If a ceiling boardsuch as plasterboardis

too weak to support the total weight, the

area shall be sufficiently reinforced.

Do not install this product in a humid or

dust-laden environment.

Otherwise, lifetime of the internal parts may be

shortened.

Be sure to remove this product if it is not

in use.

Design and engineer the power supply

system to turn on/off the power of this

product.

The product has no power switch. When

installing the product, use a power supply

device equipped with the ON-OFF switch for

servicing.

About the network connection

When connecting to a network using the net-

work cable of this product, observe the follow-

ing.

 • When wiring for the network, design and

engineer not to be affected by thunder.

 • It is impossible to install this product in

combination with a pan/tilt head.

Screw tightening

 • The screws and bolts must be tightened

with an appropriate tightening torque

according to the material and strength of

the installation area.

 • Do not use an impact driver. Use of an

impact driver may damage the screws or

cause tightening excessively.

 • Tightenscrewsatarightangletothesur-

face. After tightening screws, perform visu-

al check to ensure tightening is so suffi-

cient that there is no backlash.

Procure fixing screws separately.

The screws that secure this product are not

supplied. Prepare them according to the mate-

rial and strength of the area where the product

is to be installed.

Panasonic assumes no responsibility for injuries or property damage resulting from fail-

ures arising out of improper installation or operation inconsistent with this documenta-

tion.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentários a estes Manuais

Sem comentários

Panasonic WV-SW352 Guia de Instalação Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança Panasonic WV-SW352