Panasonic WJ-ND400 Guia de Instalação descarregar pdf (Página 52)

8 Move the underscore mark below "YES" using the

arrow button (left or right), and then press the [SET]

button.

The shutdown process of the extension unit will start and

all the HDD status indicators will start blinking orange.

When the shutdown process is complete, all the HDD sta-

tus indicators will go off.

 • Whentheshutdownprocessoftheextensionuniton

which recording is being performed starts, recording

will continue on an HDD unit on another device.

Images may sometimes not be recorded for several

seconds when switching the HDD unit for recording. If

there is no device with an HDD unit for recording,

recording will stop.

When the [SET] button is pressed, the display on the LCD

will return to the time and date menu.

9 Remove all the HDD units from the extension unit

after confirming that all the HDD access indicators

are off.

(1) Hold down the removal knob on the HDD unit.

(2) Pull the lever up.

(3) Pull the HDD unit out from the HDD slot.

Pull the HDD unit out carefully so as not to drop it and

handle it gently so as not to give it a shock or vibration.

Close the front cover and lock it by pushing and

turning the key to the left.

Keep the key in a safe place.

Check the disk information.

The following can be checked on the "Disk information"

page on the setup menu. Refer to the setup instructions

(PDF) for further information.

 • Totalcapacityoftheharddiskdrive

 • Availablecapacityoftheharddiskdrive

 • Hourmeter

 • Operationalmodeoftheharddiskdrive

 • Timeanddaterangeoftheimagesrecordedonthe

hard disk drive.

Note:

 • ItisimpossibletoremovealltheHDDunitsintheexten-

sion unit using the buttons and the LCD on the front panel

when running in the RAID 5 or RAID 6 mode. Refer to

page 55 for information on how to replace a faulty hard

disk drive.

● Determine the operational mode

The default operational mode is "Single".

To run the system in the single mode, the following procedures

are not necessary.

1 Turn off the power of the recorder.

Turn off the power of the recorder by following the instruc-

tions in the "Turn off the power of the recorder" (page 40).

2 Turn on the power of the recorder after turning on

the power of all the connected extension units.

(3)

(2)

(1)

(2)

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Comentários a estes Manuais

Sem comentários

Panasonic WJ-ND400 Guia de Instalação Página 52

Comentários a estes Manuais

Manuais e produtos relacionados com Matrizes de discos Panasonic WJ-ND400