Panasonic WJ-ND400 Guia de Instalação descarregar pdf (Página 14)

■ Inside the front cover

q [USE] button

Use this button when adding/replacing the HDD units, or

when changing the operational mode.

Installing/removing an HDD unit: Hold down the button

for 2 seconds or more until the buzzer sounds. When

the buzzer sounds, the recorder is ready for installa-

tion/remove of the HDD units using the buttons and

the LCD on the front panel.

Changing the operational mode: Select the operational

mode by determining the [RAID] switch position, and

then turn on the power of the recorder by pressing the

[POWER] switch while holding down the [USE] button

until the buzzer sounds. The recorder will start up in

the selected operational mode.

w HDD units

Only the hard disk drive encased in the dedicated hard

disk drive canister (HDD units) can be installed in the

recorder.

It is possible to add/replace the HDD unit by operating the

buttons and the LCD on the front panel. Refer to page 46

for further information. Contact your dealer about purchas-

ing/replacing hard disk drives.

e HDD status indicator (STS)

Indicates the operational status of the respective hard disk

drive.

Lights green: Indicates that the power of the respective

hard disk drive (formatted) is on.

Blinks green: Indicates that the respective hard disk drive

is for playback use only.

(Recording is unavailable using the respective hard

disk drive.)

Blinks orange: Indicates that the respective hard disk drive

is currently being formatted.

Lights red: Indicates that formatting of the respective hard

disk drive has failed.

Off: Indicates that the power of the respective hard disk

drive is off, or that the hard disk drive is not connect-

ed/recognized.

r HDD access/failure indicator (A/F)

Indicates the status (access/failure) of the respective hard

disk drive.

When an HDD failure (error) occurs during operation in the

RAID 5/RAID 6 mode, the indicator will light/blink red.

Blinks green: Indicates that the respective hard disk drive

is being accessed.

Off: Indicates that the respective hard disk drive is not

being accessed.

Lights red: Indicates that the respective hard disk drive is

faulty (which can be recovered by replacing the hard

disk drive)

In the RAID 5 mode, it indicates that the hard disk

drive is the first faulty drive.

In the RAID 6 mode, it indicates that the hard disk

drives are the first and second faulty drive.

Blinks red: Indicates that the respective hard disk drive is

faulty (which cannot be recovered even by replacing

the hard disk drive)

In the RAID 5 mode, it indicates that the hard disk

drive is the second faulty drive.

In the RAID 6 mode, it indicates that the hard disk

drive is the third faulty drive.

Lights red and orange alternately: Indicates that the

respective hard disk drive is currently being recovered

in the RAID 5/RAID 6 mode.

(It may appear that the indicator lights orange when

recovery is being processed at high speed.)

q w e r t

y u

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Comentários a estes Manuais

Sem comentários

Panasonic WJ-ND400 Guia de Instalação Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Matrizes de discos Panasonic WJ-ND400