Panasonic KXTCD820E Manual do Utilizador Página 4

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 6
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 3
4
5 Frequently asked questions
Question Cause & solution
What kind of power outlet
should I connect the AC
adaptor to?
Connect the AC adaptor to a 220–240 V outlet.
Why is w flashing? L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L The handset is not registered to the base unit. Register it.
" (centre of joystick) i m i # i
Registration i # i Register H.set i
# i Select a base unit number. i # i Press
and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds. i Wait until Enter Base
PIN is displayed. i Enter the base unit PIN (default:
0000). i #
Why is the handset display
blank?
The handset is not turned on. To turn the power on, press
{ih} until a short beep sounds.
What should I do when the
handset does not turn on?
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
How long should I charge new
batteries?
Charge the batteries for about 7 hours.
How long is the battery
operating time?
When you are using fully-charged Ni-MH batteries;
Talking: 14 hours max.
Standby: 150 hours max.
L Battery operating time may be shortened over time
depending on usage conditions and ambient
temperature.
When should I replace the
batteries?
If the batteries are fully charged until
!
is displayed, but
#
is displayed after a few calls, replace the batteries with new
ones.
What is a PIN? The PIN is a 4-digit number that must be entered in order
to change certain handset and base unit settings. The
default PIN for both the handset and base unit is 0000.
What do I need to do to
display caller information?
You need to subscribe to Caller ID service. Consult your
service provider for details.
TCD820E_QG(e).fm Page 4 Wednesday, July 13, 2005 5:40 PM
Black process 45.0° 60.0 LPI
Vista de página 3
1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários