Panasonic TXP50C3B Instruções de Operação descarregar pdf (Página 75)

FAQs | On screen messages

Problem Actions

Other

The TV does not switch

•

Press and hold the standby On / Off switch on the remote control for about 1 second if

Power LED is red.

•

Check the mains lead is plugged into the socket.

•

The fuse in the mains plug may have blown. Replace it with one of an identical rating

(p.4)

The TV goes into

Standby mode

•

Auto power standby function is activated. (p.9)

•

The TV enters Standby mode about 30 minutes after analogue broadcast ends.

The remote control

does not work or is

intermittent

•

Are the batteries installed correctly? (p.6)

•

Has the TV been switched On?

•

The batteries may be running low. Replace them.

•

Point the remote control directly at the front of the TV (within about 7 m and a 30

degree angle of the front of the TV).

•

Situate the TV so that sunshine or other sources of bright light do not shine on the TV’s

remote control signal receiver.

Parts of the TV become

hot

•

Temperature rises of parts of the front, top and rear panels will not pose any problems in

terms of performance or quality of the TV.

An error message

appears

•

Follow the message’s instructions.

•

If the problem persists, contact your local Panasonic dealer or the authorized Service

Centre.

On screen messages

Message Meaning / Action

All tuning data will be erased

•

[Shipping Condition] will erase all tuning data (p.47)

Are you sure ?

•

Confirm correct operation.

Are you sure you want to delete

this timer?

Press OK to delete timer.

Press RETURN to return.

•

Confirm correct operation.

Bad signal

•

The signal is weak. Check the aerial is plugged in properly. It may be necessary to

have an aerial installer check the signal and aerial alignment.

•

Reset channels. (p.36)

Child Lock is active!

Press OK to enter PIN.

•

The selected channel is locked in Child Lock (p.43). You must enter the PIN number

before the channel will be displayed.

Feature not available.

•

It is not possible to record from COMPONENT or HDMI. Connect the recorder to the

TV using a fully wired SCART cable for recording from the TV tuner.

•

Confirm Q-Link or VIERA Link settings (p.58 - 61)

Feature not available.

Press OK to view how it works.

•

The selected feature on VIERA TOOLS is not available. Press the OK button to view

the demonstration to explain how to use it.

Found new software version

∗∗∗

Press

OK to start update (may

take over 40mins) or press EXIT

to ignore and you can update

when TV is in standby

•

There is a new software available.

Invalid operation - Please check

settings and connections.

•

Check the Q-Link or VIERA Link connection and setting (p.58 - 61)

Invalid system time. Please exit !

•

Cannot get the time information and cannot edit TimerProgramming screen.

Check the connection of the RF cable.

Invalid system time, Timer

Programming will not work.

Please press TV button on

remote control and check time

display on Banner

•

Cannot get the time information. If there is no time displayed on the Information

banner, check the connection of the RF cable.

Max. number of timers already

set !

•

The maximum number of timer programming events is 15.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80

Comentários a estes Manuais

Sem comentários

Panasonic TXP50C3B Instruções de Operação Página 75

Comentários a estes Manuais

Manuais e produtos relacionados com TVs LCD Panasonic TXP50C3B