Panasonic BM-ET500 Manual do Utilizador

Before attempting to connect or operate this product,please read these instructions carefully and save this manual for future use.Model No. BM-ET500Ir

10MAJOR OPERATING CONTROLS AND THEIR FUNCTIONSq Status IndicatorShows the status of recognition or enrollment.ACCEPT: Lights up when recognition has b

11INSTALLATIONS AND CONNECTIONSWARNINGThe installation described in these figures should be madeby qualified service personnel or trained system insta

122. Remove the shipping lock as follows:• Take care not to drop the screw inside the unit.• You can use an M3 screw if you have lost this screw.3. Re

134. Attach the unit to the mounting bracket.You need to make a hole of approx. ø 30 mm on the wall to pass the cables out of the rear side.5. Connect

14DIMENSIONS OF THE MOUNTING BRACKET6.5 22.5M54945180.5 186.59047180.5 174.539826634-φ108124.289.4173.799.322R1(Unit of length: mm)

15ADJUSTMENTS AND MAINTENANCE Adjustment● Adjusting the Buzzer LevelAdjust the buzzer level, which informs you of recognitionresults, as follows.1. O

16RECOGNITION PROCEDURESThere is two ways of identification:• Iris recognition• ID-and-password authorizationNote: When “READY” is blinking, recognit

17Notes:• The capturing range is as follows.• The height of the unit, shown in the figure, is recommendation. Center of optical axis and upside/downsi

18ADDITIONAL SYSTEM COMPONENTS Control Unit BM-ED500This product is necessary for iris data recognition/enroll-ment and controlling an electric lock.

19Enrollment/Recognition is invalid.TROUBLESHOOTINGCheck to see the following before request for repair.If a trouble cannot be corrected even after ch

2The serial number of this product may be found on the bot-tom of the unit.You should note the serial number of this unit in the spaceprovided and ret

20The status indicator does not light up. The power of the control unit may beturned off. (The control unit supply thepower to the unit.)Third party e

21GeneralPower source: 32 V, 3 A DC (when supplied from Control Unit BM-ED500)24 V, 4 A DC (when supplied from an external power supply device*)Power

22Operating instructions (This document)*1... 1 pc.The following parts are used during installation procedures.M

23

NM0702-3063 3TR001094DAA Printed in Japan2003 © Matsushita Electric Industrial Co., Ltd. All rights reserved.PANASONIC CANADA INC.5770 Ambler Drive,

3IMPORTANT SAFETY INSTRUCTIONS1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all instructions.5) Do not use this

4CONTENTSIMPORTANT SAFETY INSTRUCTIONS ...

5PREFACEIris Camera BM-ET500 is used in an access control system. The iris camera, which captures a user's iris image with the controlby Control

6FEATURES• Automatic guidance and recognition by two camerasWhen a user approaches within 66 cm {2.16 ft.} of the front of an iris camera, iris image

7NOTIFICATION ABOUT THIS DOCUMENT• This document describes basic operating instructions of Iris Camera BM-ET500. • The operating instructions supplied

8DOCUMENT CONVENTIONThese operating instructions use the following convention when describing the use and operation of the camera.Access control syste

9PRECAUTIONS• Refer all work related to the installation of thisproduct to qualified service personnel or systeminstallers.Consult an expert on the lo