Panasonic VL-GC001A Manual do Utilizador

Thank you for purchasing a Panasonic Door Station.Please read this Installation and Operation Guide before using the unit and save for future referenc

10Introduction and Installation2 Attach the mounting bracket to the wall using the wood screws (3.8 mm x 20 mm, 1/8'' x 13/16'').L

11Introduction and InstallationL If you want to connect the wires without them going through a hole in the wall behind the mounting bracket, connect t

12Introduction and Installation5 Insert the hex-head screw using the longer end of the allen wrench.6 Attach the bolt cover using the shorter end of t

13HelpCleaningClean the unit with a soft, dry cloth when cleaning. For excessive dirt, wipe the unit with a slightly damp cloth.Important information:

14General InformationTechnical data about this productPower supply*1: Standby: Approximately 5 V DC (2 mA)At operation: Approximately 20 V DC (180 mA)

15General InformationFCC and Other InformationThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions

For your future referenceAttach your sales receipt here.Panasonic Consumer Electronics Company, Division of Panasonic Corporation of North AmericaOne

2Table of ContentsImportant InformationImportant safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3Important InformationImportant safety instructions1) Read these instructions.All the safety and operating instructions should be read before the appl

4Important InformationAdditional safety information1. Use only the power source marked on the unit. If you are not sure of the type of power supplied

5Introduction and InstallationIncluded items12345No. Item Quantity Notes1 Door station 1 ------2 Mounting bracket 1 Attached to rear of the door stati

6Introduction and InstallationLocation of controlsFront view Rear viewA CameraL When a visitor presses the Call Button, the camera will turn on and an

7Introduction and InstallationBefore installationTo avoid malfunction or communication disturbances, do not install the door station in the following

8Introduction and InstallationNote:L The measurements and angles are for reference purposes and may vary depending on the environment.L If a strong li

9Introduction and InstallationInstalling the door stationMake sure to install the door station on a flat, vertical wall.Important information: On the